Boat Anchor The Principle Of Action

First of all, Boat Anchor under the conditions of the anchor, not any place can be anchored, the best substrate is the bottom of the sand, mud bottom Second, the reef base is difficult to anchor, it may be difficult to grasp the poor, Anchor. Water depth is too large, such as in the ocean, three or four kilometers of water depth, can not break down. (But can drag the anchor sailing, this is a big fight against the storm skills, here is not to say)

When you break down, Boat Anchor you can not use too fast speed, to slowly down the anchor, the speed will lead to anchor and anchor chain is difficult to stop, may damage the windlass, and may even have other serious consequences. The anchor first is the anchor crown bottom, and then the anchor body lying down, Boat Anchor then under the action of the balance bar, the tip of the anchor will touch the bottom, but will not catch the sand. The boat will continue to lay down a certain length of the chain, so that most of the anchor chain are tiled in the sea. Then move back the car, the chain will be slightly dragged back, anchor 6 in the anchor body under the combined force of gravity and anchor, it is inserted into the sand.

At this point, Boat Anchor the ship will slightly recover some of the chain. In general, the release of the chain length should be 3-5 times the water depth. If the chain is too long, the range of the ship is increased and it is easy to collide with other anchored vessels. Anchor chain is too short, it is easy to affect the anchor up, so that the anchor loose, loss of grip effect. In the anchor grasping grip, the equivalent of playing a pile, and the anchor chain in the down, basically only with the level of the substrate tension, in this angle, the anchor is the largest grip. Unless the storm is very large, the general anchor can be grasped.

In the anchor, Boat Anchor the ship forward moving car, while slowly recovering the anchor chain, from the anchor at the nearest, straighten the chain, then the anchor point A point in the anchor will pull under the anchor, anchor will anchor B is the axis, the use of the principle of leverage will anchor p out from the bottom, and then continue to recover the anchor chain, until the anchor out of the water.